How to use the incubator?

1. Ensure that the power supply is safe before use; choose normal eggs; not the total weight of eggs specified by the incubator; put the machine in the room, keep the temperature at 14~30℃, and there should be no chemicals or high-vibration items in the room.
2. Connect the power to the incubator about 16 to 24 hours before preparing to hatch, and do not add water to the water tank in the incubator.
3. After 16~24 hours of operation, start adding water, the water level should not exceed the mark (A, B), and the water level should be 50%~65%. Below 4mm water depth. After adding the water, place the selected eggs on the grid.
4. Cover the incubator, close the bottom, and test whether the machine is normal by electrifying it. The sound is abnormal.
5. After 2 minutes, the red indicator lights up, indicating that the incubator starts to heat; about 8 minutes later, the indicator light of the incubator will flash, indicating that the incubator is working at a constant temperature.
6. Check the water level in the sink every day. If there is less water, add water in time. Add water to one sink, the humidity is 50-60%, and two sinks add 70-85%. The water depth is not higher than 8mm in the tank. The water level should not exceed two sink surfaces.
7. From the third day, turn the eggs every morning and evening or every 12 hours. Make sure to turn the eggs at least twice a day. The angle of turning the eggs is 180 degrees, and the other side of the eggs is facing up. , Put the edge in the middle, and put the edge in the middle, which is beneficial to improve the hatching rate. When turning the eggs, you should also check the water in the sink.
8. When hatching, do not turn the eggs for the last two days.